Clevo NL50MU - Page 32

Disassembly
2 - 8 Removing the Battery
2.Disassembly
6. Carefully disconnect the cable , then remove screws - (Figure 2d).
7. Lift the battery off the computer (Figure 2e
).
8. Reverse the process to install a new battery (do not forget to replace all the screws and bottom cover).
9. Make sure you close the bottom cover by applying pressure at point as shown (Figure 2f
).
15
16
19
20
21

20. Battery
•4 Screws
Figure 4
Battery Removal -
48WH (cont’d.)
c. Disconnect the cable and
remove the screws.
d. Lift the battery off the
computer.
f. Close the bottom cover
as shown.

Powering the
Computer On
After every disassem-
bly, make sure that the
bottom case’s screws
are all inserted and
tightened before turn-
ing the computer on.
d.
20
17
16
18
e.
15
19
f.
21
21