Clevo P775DM2-G - Processor Removal and Installation

Disassembly
2 - 12 Removing and Installing the Processor
2.Disassembly
Removing and Installing the Processor
Processor Removal Procedure
1. Turn off the computer, remove the battery (page 2 - 5), and component bay cover (page 2 - 10).
2. Remove screws - from the heat sink unit in the order indicated on the label (i.e screw first through to
screw last Figure 8a)
.
3. Carefully (it may be hot) remove the heat sink unit (Figure 8b).
1
9
9
1
10
Figure 8
Processor
Removal
Procedure
a. Remove the screws
in the correct order.
b. Carefully remove
the heat sink unit.

10. Heat Sink Unit
•9 Screws
a.
b.
Note:
Loosen the screws in the reverse
order 9-8-7-6-5-4-3-2-1 as indicat-
ed.
6
5
8
7
4 1
2 3
9
10