BIOS Utilities
Advanced Menu 5 - 15
5
If you wish to change your SATA mode to/from AHCI/Intel RST Premium mode
you will receive a message (see overleaf) to notify you that doing so may prevent
your operating system from booting, and may require a reinstall of the OS. If you do
wish to change the SATA mode then backup any necessary data on your hard disk(s)
as you will need wipe the disks clean in order to prevent system problems.
Power On Boot Beep (Advanced Menu)
Use this menu item to enable/disable the beep as the computer starts up.
Battery Low Alarm Beep (Advanced Menu)
Use this menu item to enable/disable the battery low alarm beep.
SATA Mode
Selection
If you have installed the
Windows OS with ei-
ther AHCI or Intel RST
Premium mode en-
abled, DO NOT disable
the set mode (if you wish
to disable the set mode
you will need to reinstall
the Windows OS).
Note that your system
can be set up as a
RAID OR to support In-
tel® Optane™, it can-
not be set to support
both systems.
Figure 5 - 7
SATA Mode Change
Notification
To Next Page
Loading...
