ClimateMaster Console CCE Series - Start-Up Log

29
c l i m a t e m a s t e r. c o m
C o n s o l e s
R e v. : 0 8 / 1 3 / 1 0
T H E S M A R T S O L U T I O N F O R E N E R G Y E F F I C I E N C Y
Start-Up Log
Installer: Complete unit and system checkout and follow unit start-up procedures in the IOM. Use this form to
record unit information, temperatures and pressures during start-up. Keep this form for future reference.
Job Name: ________________________________ Street Address: __________________________________
Model Number: ____________________________ Serial Number: ___________________________________
Unit Location in Building: ____________________________________________________________________
Date: ________________________________ Sales Order No: _______________________________________
In order to minimize troubleshooting and costly system failures, complete the following checks and data entries
before the system is put into full operation.
Temperatures: C Antifreeze: _____%
Pressures: kPa Type __________________
Cooling Mode Heating Mode
Entering Fluid Temperature
Leaving Fluid Temperature
Temperature Differential
Return-Air Temperature DB WB DB WB
Supply-Air Temperature
DB
WB DB WB
Temperature Differential
Water Coil Heat Exchanger
(Water Pressure IN)
Water Coil Heat Exchanger
(Water Pressure OUT)
Pressure Differential
Compressor
Amps
Volts
Discharge Line Temperature
Motor
Amps
Volts
Allow unit to run 15 minutes in each mode before taking data.
Do not connect gage lines