9
English
TERMINAL EVOLUTION
SCREENS “N”
Screen “N1”
Used for clock settings
SCREENS “O”
Screen “O1” & “O2”
Used to activate manually the unit and also each single com-
ponenets installed on it.
Screen “O3” & “O4”
Used to check all contact available on board
SCREENS “P”
These screens are of foundamental importance for the right unit
functionig. Keep strong attention before to modify them, and even-
tually keep in contact with the manufacturer.
Any wrong use of this screens will make immediately decline any
warranty responsibility from the manufacturer.
Screen “P1”
Used to set the main importat/foundamental features of each unit
Screen “P2”
Used to set eventually optional sensors
Screen “P3”
Used to set the Remote ON-OFF via el. Contact and the time
costants values for water valves 3 points.
Screen “P4”
Used to modify parameters related to Electronic backward curved
EC Fans, like:
• Standard speed
• Energy saving speed when uniti s not in regulation.
Screen “P5”
Used to modify parameters related to Electronic backward curved
EC Fans, when it is related to 3 way chilled water valve.Then this is
screen is availavle only for AC* (chilled water unit).
Screen “P6”
Used to activate the Emergency Mode: when the dedicated contact
on the board activate the Emergency mode, only the components
reported inside this screen remain in ON, in order to save energy.
Screen “P7”
Used to modify and set Humidifier parameters.
Screen “P8”
Used to temporary disabling the Humidifier in order to provide its
maintenance or replacement.
To Next Page
Loading...
