Climax Air Inc. www.climax-air.com
CARE AND MAINTENANCE
IMPORTANT:
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired or replaced
By the manufacturer or its dealer.
1. Air filter
- Clean the air filter at least once every two weeks to prevent
Reduced fan operation because of dust accumulation.
- Removal
This unit has two filters. Take the air filters out as shown Fig.23.
- Cleaning
Wash the air filter by immersing it gently in warm water
(about 40°C/104°F) with a neutral detergent. Rinse the filter and
dry it in a shady place.
- Mounting
Install the air filters after cleaning as shown Fig.24..
2. Unit enclosure
- Use a lint-free cloth soaked with neutral detergent to clean
the unit enclosure. Finish by drying with a clean cloth.
3. When the unit is to be idle for a long time
- Remove the rubber plug at the back of the unit and attach
a hose to drain outlet. Place the open end of the hose
directly over an appropriate draining area. (See Fig.20 & 21).
- Remove the plug from the bottom drain outlet, any water
in the bottom tray will drain out (See Fig.22).
Keep the appliance running on FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold
from forming.
- Stop the appliance and unplug it, wrap the cord and
bundle it with tape(Fig.25). Remove the batteries from
the remote controller.
- Clean the air filter and reinstall it.
To Next Page
Loading...