20
Climax Air Inc. www.climax-air.com
Location of the remote controller.
• Use the remote controller within a distance of 25
feet from the appliance, pointing it towards the
receiver. Reception is confirmed by a beep.
The remote controller is powered by two dry cell
batteries (R03/LR03X2) housed in the rear
part and protected by a cover.
(1) Remove the cover by pressing and sliding off.
(2) Remove the old batteries and insert the new
Batteries, placing the ( + ) and ( - ) ends correctly.
(3) Reattach the cover by sliding it back into position.
NOTE: When the batteries are removed, the
remote controller erases all programming.
After inserting new batteries, the remote
controller must be reprogrammed.
Handling the remote controller
• The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit.
• Prevent any liquid from falling into the remote controller. Do not expose
the remote controller to direct sunlight or heat.
• If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to prevent the
sunlight from falling on the receiver.
• If other electrical appliances react to the remote controller, either move these appliances
or consult your local dealer.
To Next Page
Loading...