26
Climax Air Inc. www.climax-air.com
Timer operation
Press the TIMER ON button can set the auto-on
time of the unit. And press the TIMER OFF button
can set the auto-off time of the unit.
To set the Auto-on time
1. Press the TIMER ON button. The remote
controller shows TIMER ON, the last Auto-on
setting time and the signal “h” will be shown on
the LCD display area. Now it is ready to reset the
Auto-on time to START the operation.
2. Push the TIMER ON button again to set desired
Auto-on time. Each time you press the button,
the time increases in 30 minute increments, up
to 10 hours, then at 1 hour increments up to 24
hours.
3. After setting the TIMER ON, there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal “h” will disappear and the set temperature
will re-appear on the LCD display window.
To set the Auto-off time
1. Press the TIMER OFF button. The remote
controller shows TIMER OFF, the last Auto-off
setting time and the signal “h” will be shown on
the LCD display area. Now it is ready to reset the
Auto-off time to START the operation.
2. Push the TIMER OFF button again to set desired
Auto-off time. Each time you press the button,
the time increases in 30 minute increments, up
to 10 hours, then at 1 hour increments up to 24
hours.
3. After setting the TIMER OFF, there will be a one-
half second delay before the remote controller
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal “h” will disappear and the set temperature
will re-appear on the LCD display window.
To Next Page
Loading...