CLIVET ELFOFresh2 CPAN-U 70-120 Series - DY200 X - DN200-DN200-DN200 Y-joint; DY250 X - DN250-DN200-DN200 Y-joint; For the 500 and 650 ELFOFresh² units, two air distribution boxes...

BT15B012GB-00 ELFOFresh² 51
GIUTX - Connecting joint for DN90 round tube
The connection between two sections of a round exible tube must be eected using the appropriate joint.
The connection is eected on both sides of the joint using 1 sealing ring mounted on the second rib of the tube, by means of
a quick-mount pressure tting system.
CT90X - Printed curve of 90-degree angle for DN90 round tube
Flexible round tubes can be bent with a minimum radius of curvature of 150 mm.
If the bend must have a smaller radius, 90° stamped elbows can be used.
The corrugated tube is joined to both ends of the elbow by means of a quick-mount pressure tting system.
Lastly, a sealing ring must be mounted on the second rib of the two tube sections.
Dp = pressure drop
Q = Air ow
A90DTX - 90-degree adaptor, double DN90 round tube for DN125 valve + cap
This allows you to connect the extraction and intake valves to the air distribution system with a round
tube. It is equipped with two air inlets for a maximum airow rate of 120m³/h. If the airow rate through
the valve is below 60m³/h, a single inlet is sucient; the other inlet will remain closed with the relevant
closing cap supplied with each adapter.
When cutting the cap you can shorten the cylindrical segment to the desired size with a cutting tool.
The segment has reference marks to facilitate this operation.
The valve adapter is supplied closed and ends with a round cap to be cut after the building work, so as to
prevent dust and dirt from entering the exible tubes.
Dp = pressure drop
Q = Air ow
No. 1 Cap included with the supply