Installation
Page 141
unit’s height can be adjusted by loosening the upper nut,
and adjusting the lower nut.
3. Hang the intake grille on the panel, and then connect
the lead connectors of the louver motor and the control
box on the panel to the corresponding connectors of the
main body.
4. Re-installed into the style grid.
5.Reinstall the installation cover.
Fix the installation cover plate rope to the pillar of the
installation cover plate, and gently press the installation
cover plate into the panel.
Panel hook
When installing the
slide fasteners into
the corresponding
NOTE: After installation, the butt plugs of display, swing,
water pump and other wire bodies must be placed in the
electric control box.
11.2 Box 2 650x650 Panel Installation
11.2.1 Remove the front grille
1. Slide the 2 grille hooks toward the middle of the
decoration panel.
2. Hold the grille at a 45° angle, lift it up slightly and
detach it from the main body.
11.2.2 Install the panel
1.Align the indicate “ ” on the decoration panel to the
indicate “ ” on the unit .
2. Attach the decoration panel to the unit with the
supplied screws as shown in figure below.
3.After installing the panel, ensure that there is no space
between the unit body and decoration panel. Otherwise
air may leak through the gap and cause dewdrop.
11.2.3 Mount the grille
To Next Page
Loading...
