CLIVET MC3-Y 140T - Indoor Unit Installation

Installation
 Page 130 
3. Indoor Unit Installation
3.1 Service space for indoor unit
For BOX 2 650x650,
For Box 2 950x950,
＞400cm / 157.5”
＞200cm / 78.7”
＞150cm / 59.1”
＞150cm / 59.1”
(200cm / 78.7”
recommended)
Ceiling
Ground
Indoor unitIndoor unit
Illumination
Ventilator
>230cm / 90.6”
Ceiling
H
Front panel
Ceiling board
B (Ceiling hole)
Ceiling
A
SIZE
A(mm/inch) H(mm/inch) B(mm/inch)
70M
205/8.07 >230/9.06
900/35.4
88M-105M
245/9.65 >271/10.7
120M-160M
287/11.3 >313/12.3
3.2 Hang Indoor Unit
1. Use the included paper template to cut a r
ectangular
hole in the ceiling, leaving at least 1m (39.4”) on all sides.
The cut hole size should be 4cm(1.6”) larger than the boby
size.
Be sure to mark the areas where ceiling hook holes will be
drilled.
For Box 650x650,
1 Suspension bolt pitch dimensions
2 Body dimensions
3 Decoration panel dimensions
4 Refrigerant piping
5 Suspension bolt (×4)
6 Ceiling opening dimensions
7 Hanger bracket
8 Ceiling board