CLIVET WSAR-MT-E - Page 60

60
7 - REGULATION
num Description
Electrical
Refrigerant
Hydraulic
Reset
Manual
Automatic
Alarm
Prealarm
E 00 Base keypad Timeout E/F/I A A
E 01 Input temp. probe utility side E A A
E 02 Supply temp. probe utility side E A A
E 03 Outside temp. probe E A A
E 04 Coil temp. probe E A A
E 06 Temp. probe in accumulation E A A
E 07 AUX. heater temp. probe (utility side) E A A
E 08 Pressure 1 probe (HP) E A A
E 09 Pressure 2 probe (LP) E A A
E 10 Ext. RH% probe E A A
E 11 Water Reset input E A A
E 12 Demand Limit input E A A
E 13 Phase monitor E A A
F 01 High pressure (HP) F A/M A
F 02 Low pressure (LP) F A/M A
F 03 Compressor 1 overload (or softstater) F M A
F 05 Prealarm HP1 F A P
F 06 Prealarm LP1 F A P
F 07 Fan overload F M A
f/F 10 Max pressure ratio F A/M P/A
f/F 11 Defrosting forcing for low pressure F A/M P/A
I 01 Utility pump flow I A/M A
I 03 Pump 1 overload (utility side) I M A
I 04 Pump 2 overload (utility side) I M A
I 05 Frost alarm (utility) I M A
I 06 Frost alarm I M A
I 07 AUX heater antifreeze I M A
I 08 Water charge system (utility) I M A
I 09 Incongruent T Delta I M A
I 10 Thermal alarm on all pumps (utility side) I M A
I 11 Antifreeze prealarm (utility) I A P
I 12 Pump change (utility) I A P
I 13
User input water temperature out of limit of the current operating
mode
I A P
I 14 Dom. hot water incongruent thermostat I A P
I 15 Ambient antifreeze alarm I A A
LIST OF ALARMS