8
Operate in compliance with safety regulations in force .
For detailed information (dimensions, weight, technical
characteristics etc.) please refer to the “Technical information”
section.
Use single protection devices : gloves, glasses ecc. .
2.1 PRELIMINARY INFORMATION
Before accepting the delivery you have to check:
• That the unit hasn’t been damaged during transport.
• Check that the materials delivered correspond with that
indicated on the transport document comparing the data
with the identification label ‘A’ positioned on the
packaging.
In case of damage or anomaly:
• Write down on the transport document the damage
you found and quote this sentence: "Conditional
acceptance — clear evidence of deficiencies/
damages during transport".
• Contact supplier and the carrier by fax and registered
mail with advice of receipt.
Any disputes must be made within the 8 days following the
delivery. Complaints after this period are invalid.
2.2 DELIVERY CONTROL
2.4 HANDLING
2 - RECEPTION
Observe external packing instructions .
Be careful not to damage the unit.
Recycle and dispose of packing material in conformity with
local regulations.
2.3 STORING
Verify unit weight and handling equipment lifting capacity .
Identify critical points during handling (disconnected routes,
flights, steps, doors).
Verify the position of the barycentre in the TECHNICAL
INFORMATION - DIMENSIONS section.
Before handling verify that the unit keeps its balance.
2.5 PACKING REMOVING
The unit is fixed to the wood stillage by 4 screws.
Once that the screws have been removed, use the eqipped
plugs to close the holes and avoid therefore the noise .
Lifiting with forks or crane
Use protection to avoid the unit damaging .
A
A
B
C
A
panels
B
casing
C
casing + panels
To Next Page
Loading...
Need help?
General