7 - CONTROL
Alarm list - 1
ID Description
eE0001 Fault on the phase monitor input
EE0003 Tripping of the protections of pump 1 on the user-side
EE0004 Tripping of the protections of pump 2 on the user-side
EE0005 Tripping of the protections of pump 3 on the user-side
eE0008 Tripping of the protections of the pump inverter on the user-side
ee0010 The Master unit of the ECOSHARE network does not communicate with the Slave units.
ee0011 The Slave unit with address 2 of the ECOSHARE network signals alarms in progress
ee0012 The Slave unit with address 2 of the ECOSHARE network does not communicate
ee0013 The Slave unit with address 3 of the ECOSHARE network signals alarms in progress
ee0014 The Slave unit with address 3 of the ECOSHARE network does not communicate
ee0015 The Slave unit with address 4 of the ECOSHARE network signals alarms in progress
ee0016 The Slave unit with address 4 of the ECOSHARE network does not communicate
ee0017 The Slave unit with address 5 of the ECOSHARE network signals alarms in progress
ee0018 The Slave unit with address 5 of the ECOSHARE network does not communicate
ee0019 The Slave unit with address 6 of the ECOSHARE network signals alarms in progress
ee0020 The Slave unit with address 6 of the ECOSHARE network does not communicate
ee0021 The Slave unit with address 7 of the ECOSHARE network signals alarms in progress
ee0022 The Slave unit with address 7 of the ECOSHARE network does not communicate
ee0023 The Slave unit with address 7 of the ECOSHARE network signals alarms in progress
ee0024 The Slave unit with address 7 of the ECOSHARE network does not communicate
ee0025 Failure of the water temperature sensor at the inlet of the exchange coil on the source side
ee0027 Failure of the water temperature sensor at the inlet of the heat exchanger on the user-side
ee0028 Failure of the water temperature sensor at the outlet of the heat exchanger on the user-side
ee0029 External temperature probe failure
ee0030 Demand Limit fault (Volt input)
ee0130 Demand Limit fault (mA input)
ee0031 Water Reset fault (Volt input)
ee0131 Water Reset fault (mA input)
ee0033 Faulty electrical panel temperature sensor
ee0034 Faulty temperature sensor of the second electrical panel
ee0040 Faulty water temperature sensor on FCl circuit
EE0044 FCl Pump 1
EE0045 FCI pump 2
EE0046 FCI pump 3
ee0047
It switches the pump for the flow alarm on the user-side. Only if the alarm is not manual and if there are
pumps available that are not active
ee0050 Utility side differential pressure switch
To Next Page
Loading...
Need help?
General