clivus multrum LOW PROFILE - STARTING WITH AN EMPTY CHAMBER

©Ecoflo Wastewater Management Pty LtdIMCM-203-2023.08.30
15
STARTING WITH AN EMPTY CHAMBER
Before connecting your chamber to the waste chute, add an even 50mm layer of bulking
agent and dampen slightly with water. Complete the installation of the chamber (refer to
Step 5, Install the In-Service Chamber). You can start using your chamber now.
1
After 7 days of use, mix half a packet
of microbes with warm water in a
bowl. Add this to the chamber through
the pedestal. Reseal the packet and
store it at room temperature, out of
direct sunlight.
2
Around 14 days later, add the rest of
the packet of microbes mixed with
warm water to the chamber through
the pedestal.
Your system is now fully activated with
live bacteria.
3
Repeat steps 1-3 each time you restart with an empty chamber.
4
50mm of
bulking agent
Slightly dampen the
bulking agent with water.