To Next PageTo Next Page
Need help?Do you have a question about the Clockaudio CDT100 and is the answer not in the manual?
Details the four balanced audio inputs with phantom power capability.
Instructions for connecting balanced audio sources to the CDT100.
Instructions for connecting unbalanced audio sources (2-wire and 3-wire).
Guide to setting up IP addresses for Dante Controller communication.
Explains how to use the device identification feature, flashing the power LED.
Illustrates Dante daisy chaining with C012EN RF and CH32 devices.
Audio Inputs| input type | Balanced and RF filtered |
|---|---|
| gain | 0 dB |
| input impedance | >1.8K ohms at any gain |
Audio Performance| equivalent input noise (EIN) | -115 dBu |
|---|---|
| total harmonic distortion plus noise (THD+N) | <0.01% at any gain, input signal 3 dB below maximum |
| frequency response | 20Hz – 20kHz, +/- 1dB |
Network| physical level | Standard Ethernet |
|---|---|
| connector | RJ-45 |
| transmission speed | 100 Mbps |
Power| power requirements | +12V DC |
|---|---|
| power consumption | 4.9W Max |
Weight and Dimensions| dimensions | 8.32” W x 1.50” H x 4.74” D |
|---|---|
| weight | 1.75 lbs |
