MAN. 126 rev.4 Use and maintenance manual S19
46 of 77
4.6
Safety rules
THE NON-OBSERVANCE OF ONE OF THE FOLLOWING
SAFETY RULES, MAY CAUSE SERIOUS DAMAGES TO PEOPLE,
THINGS AND PARTS OF THE EQUIPMENT OR THE VEHICLE.
4.6.1
Before and during the movements with the
MEWP in transport position
• It is forbidden to rent the MEWP without non-trained operators
and staff.
The hirer is responsible for the training of his operators and for the
staff renting the MEWP. CMC s.r.l. declines any responsibility coming
from damages to people and/or things due to the inexperience of these
operators;
•
Before starting the machine, check the tracks wear condition;
• Do not use the MEWP to perform drawing or pushing operations;
4.6.2
Before positioning the MEWP
•
Carefully and chronologically follow the instructions given in this
manual;
• Do not use the MEWP out of the environmental working
conditions described in paragraph 4.1;
•
Check that the staff allowed to use the MEWP (minimum two
people: the first operator in the basket, the second operator on the
ground), is qualified and trained and informed about the MEWP use
and maintenance rules;
•
Follow the testing instructions indicated in the “Maintenance”
section (cap. 6);
•
Check that the safety device are working and efficient;
• Some of the platform components (integrated groups for the stabilizers,
max pressure valve on the turret) which are important for the safety of
the MEWP, are calibrated in CMC s.r.l. factory and the containers are
sealed before the delivery of the MEWP to the customer
It is strictly forbidden to tamper with these components. The lack
of the sealing, according to the guarantee of the machine, causes the
revocation of the guarantee. Therefore the user will take the charge of
the responsibility for the non-correct working of the safety devices
• It is forbidden to remove or alter the safety devices;
•
Wear safety helmets;
•
Wear appropriate PPE cloths and personal safety devices;
4.6.3
During the positioning of the MEWP
• It is forbidden to operate in situations which are dangerous for
the safety of people;
• It is forbidden to operate in explosion hazard areas;
•
Check that the working area is suitable to the MEWP performances
and to the operations and that it is enough lit;
•
Check that the places for operation and the working area are
sufficiently lit and well visible;
•
If operating in a closed - or little aired - environment, ensure, before
starting the vehicle engine, that his has appropriate ventilation or
convey exhaust gases outside:
E
xhaust emissions produced by the MEWP engine are toxic;
•
Appropriately define the working area through suitable signs;
comply with the laws in force about the traffic, in case you use the
MEWP where road circulation is allowed;
•
Check that there is nobody within the MEWP action range.
To Next Page
Loading...
Need help?
General
