What to do if the aerial part of the CMC Lifting Systems does not work?
D
David BallardAug 1, 2025
If the aerial part of the CMC Lifting Systems isn't working, it could be due to several reasons. First, the hydraulic pump unit might be faulty, requiring a replacement. Second, ensure the deadman lever on the control station is switched on and properly connected. Third, the exchange electrovalve might not be energized, in which case it needs replacement. Finally, check if the emergency button is activated; if so, turn it to disable it and reset the MEWP.
A
Amy HarrisAug 6, 2025
What to do if the endothermic engine of CMC Lifting Systems is impossible to start?
J
Jessica MossAug 6, 2025
If you can't start the endothermic engine of your CMC Lifting Systems, check these potential issues: First, make sure the emergency button is not activated and disable it if it is. Second, the battery might be discharged, so replace it. Third, check the fuel level and refuel if necessary. Finally, verify the hydraulic oil level and refill if it is too low.
C
Christopher BoydAug 10, 2025
Why the consent light for stabilization does not turn on in CMC Lifting Systems?
M
Mary CabreraAug 10, 2025
The consent light for stabilization on your CMC Lifting Systems might not turn on due to several reasons: First, the aerial part of the MEWP might not be in the transport position, so place it correctly. Second, a 30A fuse on the battery side might have failed, requiring a replacement. Third, check for any wires disconnected from the battery and reconnect them.
T
Tony BlakeAug 14, 2025
What to do if the stabilizers of CMC Lifting Systems do not work?
G
Gabriella CameronAug 14, 2025
If the stabilizers on your CMC Lifting Systems aren't working, consider these possible causes: The hydraulic pump unit might be faulty and require replacement. Alternatively, the stabilizers electrovalve may not be functioning, necessitating replacement of the stabilizers limit switches.
P
Paula RuizAug 18, 2025
Why is the maneuvers speed low in CMC Lifting Systems?
K
Kirk HendersonAug 19, 2025
Low maneuver speed in CMC Lifting Systems can be caused by: pump failure, which requires replacing the hydraulic pump; low hydraulic oil level, requiring a refill; or a clogged oil filter, which should be replaced.
J
Jose JohnsonAug 23, 2025
What to do if the consent light for aerial part use does not turn on when MEWP is stabilized in CMC Lifting Systems?
A
Andrew LuceroAug 23, 2025
If the consent light for aerial part use doesn't turn on even when the MEWP is stabilized, it could be due to a few reasons. The green light itself may be defective, requiring a replacement. Alternatively, the micro-switch system might not be working, in which case you should replace the micro-switch. Also, ensure that the stabilization is complete by further extracting the outriggers until they make contact with the soil.
T
Timothy VaughanAug 27, 2025
How to fix basket leveling issues in CMC Lifting Systems?
P
patricia61Aug 27, 2025
If the basket leveling isn't working correctly on your CMC Lifting Systems, there are a couple of things to check. First, look for oil leakage and tighten the hydraulic connections if needed. Second, the cylinder seals might be worn, requiring replacement.
To Next Page
General
