CMC S23 User Manual

MAN.241 Rev.5 ENG - Use and maintenance manual S23 page 70 of 127
The more you clean the MEWP, the more you
have to lubricate it.
Cleaning the electrical/electronic parts with
water is prohibited. Failure to comply with this
requirement can cause serious damage to the
system electric machine.
To clean electrical parts, use only dry clean-
ers.
• Dry the machine thoroughly before turning it
on again (for example with compressed air).
• Make sure that moisture has not entered the
electrical engine or other parts of the electrical
system.
4.9.3 Prevention against electric light-
ning stroke
If you need to work with the machine near power
lines, the user is obliged to keep an adequate dis-
tance.
Below there are the minimum safety distances to be
kept by qualified staff according to their type of volt-
age:
Voltage field of elec-
tric line
Minimum safety dis-
tance
Up to 300 V
Avoid contact
300 V < x > 750 V
1 ft. 0 in. (30,5 cm)
750 V < x > 2 kV
1 ft. 6 in. (46 cm)
2 kV, < x > 15 kV
2 ft. 0 in. (61 cm)
15 kV < x > 37 kV
3 ft. 0 in. (91 cm)
37 kV < x > 87.5 kV
3 ft. 6 in. (107 cm)
87.5 kV < x > 121 kV
4 ft. 0 in. (122 cm)
121 kV < x > 140 kV
4 ft. 6 in. (137 cm)
It is forbidden, in any case, to touch live
electrical conductors.
4.9.4 Noise and vibrations
The manufacturer declares that the aerial platforms
have been tested according to the parameters of the
European standard 2000/14/CE, indicating a guaran-
teed sound power level shown on the CE Declaration
of Conformity of the machine. During the phases of
use of the machine for aerial operations, this value is

CMC S23 Specifications

General

Brand	CMC
Model	S23
Category	Lifting Systems
Language	English