To Next Page

To Previous Page

MAN.241 Rev.5 ENG - Use and maintenance manual S23 page 67 of 127

During the normal use of the platform, it is ab-

solutely forbidden to use electronic instru-

ments which do not meet the requirements of

the proper directive and its following amend-

ments: the additional electronic instruments

could impair good functioning of the platform

electronic components.

4.7.6 At the end of the works

➔ Before moving the machine, check that the

MEWP aerial part is set in the transport position:

check that the pantograph is on its own support,

that the telescopic boom is withdrawn and rests

on its own support;

➔ Before moving the machine, check that all the

outriggers are completely withdrawn and

blocked, that they are set in the transport posi-

tion, with the plates completely lifted.

4.8 Safety devices 

The machine is equipped with safety de-

vices designed to prevent the occurrence

of dangerous situations for the operator.

Before starting any operation, it is im-

portant that the operator checks the per-

fect functioning of these devices.

The non-functioning of a safety device,

caused by a failure or tampering, can

cause serious injury damage to the ma-

chine and consequently endanger life op-

erator. The manufacturer has designed the

machine and its devices in order to guar-

antee the maximum safety for its custom-

ers; however, the devices must be checked

periodically as described in this manual and

must never be tampered with.

Do not intervene on your own safety de-

vices. In case of tampering, the manufac-

turer declines all responsibility about any

accidents attributable to these interven-

tions.

CMC S23 User Manual

Questions and Answers: