MAN.241 Rev.5 ENG - Use and maintenance manual S23 page 7 of 127
1.4 TÜV certification
C.M.C. s.r.l. states under its own responsibility that S23
was designed and produced in compliance with US
standards ANSI/SAIA A92.20:2020 and that the ma-
chine is identical to the model submitted to control
and test for the “TÜV certification” by TÜV SÜD
America Inc.
TÜV SUD America Inc. is an OSHA recognized
NRTL and a Standards Council of Canada accredited
certification body.
1.5 Classification
The mobile elevating work platform (MEWP) S23 be-
longs to group B: the vertical projection of the center
of the area of the MEWP in different platform config-
urations specified by the manufacturer can be out-
side the tipping lines (EN 280 par. 1.4 - ANSI/SAIA
A92.20 par. 3).
As for the displacement, it belongs to type 1: travel-
ling is only allowed with the MEWP in its transport
Loading cycle: a cycle starts from the access position,
continues performing the work and finishes returning to the
access position.
configuration or in the stowed position (EN 280 par.
1.4 - ANSI/SAIA A92.20 par. 3).
1.6 Loading cycles
The machine is expected to live for 40.000 loading
cycles
(i.e. 10 years, for 40 weeks per year, for 20
hours per week, for 5 loading cycles per hour).
Within this term of time, the machine must un-
dergo at least 2 (two) deep checks (structural, me-
chanical, electric, elements, etc.), in case of partic-
ularly heavy uses (frequent use at the performance
limit, particularly unfavorable environmental condi-
tions such as steel plants, paper mills and so on) it is
better to increase checks. Anyway, it is a good
rule to have the state of the machine checked by
the manufacturer factory or by an authorized
workshop, at least every 1500 - 2000 hours of
work or once per year.
To Next Page
Loading...
Need help?
General
