MAN.241 Rev.5 ENG - Use and maintenance manual S23 page 6 of 127
1 Description and
scope
1.1 Machine definition
The machine is called S23 and it is a mobile ele-
vating work platform (MEWP):
• machine/device intended for moving persons,
tools and material to working positions, consist-
ing of at least a work platform with controls, an
extending structure and a chassis (ANSI/SAIA
92.20 par. 3);
• mobile machine intended to move persons to
working positions, where they are carrying out
work from the work platform, with the intention
that persons are getting on and off the MEWP
only at access positions at ground level or on
the chassis and which consists as a minimum
of a work platform with controls, an extending
structure and a chassis (EN 280 par. 3.1).
It is forbidden to use the MEWP with meth-
ods and/or conditions other than those
specified and approved by the manufac-
turer.
1.2 Machine purpose
The MEWP S23 is a machine which enables the op-
erators to reach the working place when this is high
positioned.
The machine has been designed for an essentially
vertical use. It must be travelled only when it is totally
folded in the transport position.
➔ The use of the machine is allowed only to
professional staff, properly trained and spe-
cialized.
1.3 CE certification
C.M.C. s.r.l. states under its own responsibility that S23
was designed and produced in compliance with na-
tional and European standards, and that the machine
is identical to the model submitted to control and test
for the “CE certification” by the Notified Institute nr.
1878 - VERICERT s.r.l. - via L. Masotti, 5 - 48124
Fornace Zarattini (RA) - Italy.
A copy of the CE Certificate is attached to the man-
ual.
To Next Page
Loading...
Need help?
General
