MAN.241 Rev.5 ENG - Use and maintenance manual S23 page 94 of 127
8.10 Safety rules during mainte-
nance
THE NON-OBSERVANCE OF ONE OF THE
FOLLOWING SAFETY RULES CAN
SERIOUSLY HARM PEOPLE OR CAUSE
SEVERE DAMAGES TO THINGS OR
PARTS OF THE MACHINE.
➔ To ensure the safety of the machine the use of
original spare parts installed by C.M.C. or by
authorized repair shops is compulsory: in
fact, some components can be calibrated only
c/or C.M.C. or in authorized workshops.
It is forbidden to perform maintenance op-
erations when the MEWP moves: make
sure that the parts to maintain are motionless
and do these operations with the chassis
power stalled, taking the keys away from the
panel;
➔ Perform the maintenance operations in a suffi-
ciently large space and suited to the sizes of the
truck: mark the area assigned for the mainte-
nance operations by suited enclosure or by a
red/white band ribbon and do not allow entrance
to unauthorized staff.
➔ Do not modify or remove safety devices.
➔ Do not modify calibrated pieces.
➔ During the washing operation, do not lead the
water jet directly on the electrical panels of the
MEWP and do not use cleansing, aggressive
chemicals dangerous for the components of the
MEWP (rubber parts, painted parts, etc.).
It is forbidden to perform any intervention
on parts of the MEWP, such as welding,
piercing, and so on, without prior written au-
thorization by C.M.C.
➔ Wear appropriate protective clothes (gloves,
goggles, etc.).
➔ During maintenance operations, be careful not to
damage the hydraulic circuit and avoid impurities
in the circuit.
➔ Before any maintenance operation that involves
the disassembly of hydraulic circuit parts, make
sure that the system is not under pressure. In or-
der to avoid violent emissions of oil, move all the
levers of the control distributors, with the MEWP
engine stalled and no component in movement.
To Next Page
Loading...
Need help?
General
