MAN.241 Rev.5 ENG - Use and maintenance manual S23 page 60 of 127
Picture 28: electropump.
It can be activated by:
o button (Picture 29) on the right side of the radio
remote control;
o lever (Picture 29) under the red sealed cap on
the left side of switching on/off box.
To activate the emergency electropump
from the switching on/off control station, it
will be first necessary to remove the seal
on the red cap, lift it and then press the
black lever below (Picture 29).
Picture 29: electropump activation buttons.
In case of emergency, switch on the elec-
tropump, repeat the emergency maneu-
vers described above, after turning the
To Next Page
Loading...
