24
8 ASSIGNING
8.1 Assigning Controllers
z You can use the ASSIGN function to re-define a control parts by data type and MIDI
channel.
z Operation：【SHIFT】ÖD#1
【Assign Controller】Ö【Locate a control part】Ö【Set
value】Ö【ENTER】Ö【Assign Channel】 Ö【Set value】Ö【ENTER】
z In the above assigning operation, to【Locate a control part, please move a control
part. For example, you can move a fader or rotate a knob, etc.
z Controller value range：0-171
z Channel value range：1-16
z Please refer to the appendix <Assignable controller list> for more information.
There are two values for the cc#144 RPN and cc#145 NRPN in <Assignable
controller list>, which are MSB value and LSB value, so the keyboard will
instruct you to set the two values.
In <Assignable controller list>, the types from cc#149 to cc#171 are switch
controllers, so they can only be assined to buttons.
To assign the keyboard aftertouch to other controller, please use the below key
function assigning.
【SHIFT】ÖA#4
【Assign A.Touch】Ö【Set value】Ö【ENTER】
8.2 Assigning Notes
z You can assign the function shortcut button F1-F6 to note on/off message and set
the MIDI channel.
z Operation：【SHIFT】ÖE1
【Assign Note】Ö【Locate a part】Ö【Set value】Ö【ENTER】
Ö【Assign Channel】 Ö【Set value】Ö【ENTER】
z In the above operation, please press a button from F1-F6 to【Locate a part】.
z The note velocity is fixed to 127.
z Note value range：0-127
z Channel value range：1-16
8.3 Assigning Program changes
z You can assign the function shortcut button F1-F6 to program change message and
set the MIDI channel.
z Operation：【SHIFT】ÖF1
【Assign Program】Ö【Locate a part】Ö【Set value】Ö
【ENTER】Ö【Assign Channel】 Ö【Set value】Ö【ENTER】
z In the above operation, please press a button from F1-F6 to【Locate a part】.
z Voice value range：1-128
z Channel value range：1-16
Refer to the appendix <Assignable controller list>, <Note list> and <GM voice
list>.
To Next Page