26
z Operation：【SHIFT】ÖD#2【Pedal Polarity】Ö【Set value】Ö【ENTER】
z Default value：1
z Value range：1-2
9.4 Pedal A Type
z If you change pedal A type from switch to continuous or vice versa, please set the
proper pedal type.
z Operation：【SHIFT】ÖE2
【Pedal Polarity】Ö【Set value】Ö【ENTER】
z Default value：1(switch)
z Value range：1-2
9.5 Pedal B Polarity
z You can set the pedal B polarity to make it work properly.
z Operation：【SHIFT】ÖF2
【Pedal Polarity】Ö【Set value】Ö【ENTER】
z Default value：1
z Value range：1-2
9.6 Pedal B Type
z If you change pedal B type from switch to continuous or vice versa, please set the
proper pedal type.
z Operation：【SHIFT】ÖF#2
【Pedal Polarity】Ö【Set value】Ö【ENTER】
z Default value：2(continuous)
z Value range：1-2
9.7 Local On/Off
z The local control decides if the MIDI data will be sent to the expansion board.
z Please refer to the appendix <MIDI route>.
z Operation：【SHIFT】ÖG2
【Local On/Off】Ö【Set value】Ö【ENTER】
z Default value：On
z Value range：On, Off
9.8 Data Dump
z Use this function to dump the instrument settings by system exclusive messages, so
you can quickly save and restore the settings.
z Operation：【SHIFT】ÖG#2
【Dump】Ö【ENTER】
z MIDI message sent：F0 00 20 63………F7
To Next Page