EDGE Installation Manual
www.cobantech.com Page 33 of 40
Wireless Microphone Receiver Installation
The COBAN EDGE wireless mic reciever is used to synchronize the wireless mic used by the officer with the EDGE
recorder.
Note: The wireless microphone receiver mount installation procedure described in the following steps and
recommended by COBAN is to install the components on the divider between the front and backseats of a vehicle.
Different installation procedures will need to be followed for installation of the system in other situations. Please
contact COBAN Technologies for more details on your specific vehicle type and installation orientation.
Secure a 3” strip of 3M Dual Lock reclosable
fastener tape to each side of the wireless
microphone receiver.
Secure a corresponding 3” strip of 3M Dual
Lock reclosable fastener tape to the center
divider of the vehicle.
Press the wireless microphone receiver onto the
CPU so that the 3” strips of 3M Dual Lock
reclosable fastener tape line up and lock into
place.
To Next Page
Loading...