Roche Diagnostics
Addendum version 1.0 · 15
cobas c 111 analyzer Revisions to cobas c 111 instrument publications
Revision 11: Additional information for preparing cuvettes
Revision 11: Additional information for preparing cuvettes
Preparing cuvettes Cuvettes are supplied and handled in cuvette segments. Each segment contains ten
cuvettes. The segments are placed on the cuvette ring of the rotor.
Each segment on the cuvette ring is represented by a button on the screen.
To avoid timing errors ensure that all available cuvette segment positions are filled.
Always replace any completely used cuvette segments. A partially used cuvette
segment does not have to be replaced.
CAUTION
Make sure that you have read and understood section Safety information on page
B-5. The following warning messages in particular are relevant:
r Personal injury or damage to the analyzer due to contact with instrument mechanism
on page B-5.
r Infection by waste solution on page B-5.
Publication title Publication version Software version Publication date Revised topic title
Operator’s Manual 4.1 4.1 October 2013 Daily operation
> Preparing the system
> Preparing cuvettes
Table 12 Revision location
For information on cuvette segments, see Cuvette segments on page A-55.
For information on the cuvette ring, see Cuvette ring on page A-60.
To Next Page
Loading...
