cobas c 111 - Revision 14: Additional Information for Checking the Cuvette Status in the Short Guide

Roche Diagnostics
18 Addendum version 1.0 ·
1 cobas c 111 analyzer
Revisions to cobas c 111 instrument publications
Revision 14: Additional information for checking the cuvette status in the short
guide
Short guide The following table provides an overview of the steps that make up the preparation
process.
Publication title Publication version Software version Publication date Revised topic title
Operator’s Manual 4.1 4.1 October 2013 Daily operation
> Finishing the shift
> Short guide
Table 15 Revision location
7
Check the cuvette status. To avoid timing errors ensure that all available cuvette
segment positions are filled.
Always replace any completely used cuvette segments. A
partially used cuvette segment does not have to be replaced.
Replace at least all red cuvette segments.
1. Press the cuvette button.
2. Open the main cover.
3. Replace the cuvette segment.
4. Close the main cover.
5. Press to proceed to the next stage in the End Shift
wizard.