Roche Diagnostics
6 Addendum version 1.0 ·
Revisions to cobas c 111 instrument publications cobas c 111 analyzer
Revision 2: Additional information for sample measurements with a post-dilution
Revision 2: Additional information for sample measurements with a post-dilution
Dilution Pre-dilution may be used when performing calibrations and measurements.
Predilution is part of the application definition and cannot be changed the operator.
Post-dilution is run when a re-run is requested by the operator after a measurement
has finished. The post-dilution factor cannot be changed or altered by the operator; it
is predefined.
(The dilution factor is part of the application definition and therefore does not need
to be defined by the operator.)
Publication title Publication version Software version Publication date Revised topic title
Operator’s Manual 4.1 4.1 October 2013 Introduction to the instrument > Daily
operation > Sample handling
Table 3 Revision location
To Next Page
Loading...