Chapter 2: Operation
30 DSC calls
Printing DSC calls
If a printer is connected to the SAILOR 6300 MF/HF DSC via LAN you can
print DSC messages automatically. You can also print entire DSC call logs.
To set up a default printer, do as follows:
1. Go to SETUP and use the arrow keys to advance to System Setup
2. Select Printer Config:.
3. Select one printer as the default printer and push the selector knob to
enter the choice.
To print DSC messages, do as follows:
1. Go to SETUP and use the arrow keys to advance to DSC Setup.
2. Use the selector wheel to scroll to Print DSC.
3. Set Print DSC: to ON.
To print DSC call logs, do as follows:
1. Go to SETUP and use the arrow keys to advance to DSC call logs.
2. Select the call log you want to print.
3. Push the soft key PRINT.
A printer attached to the SAILOR 6004 Control panel can be used, or a
generic LAN based line printer.
Routine calls on e.g. 2177 kHz are not automatically monitored on all
radios. Enabling DSC mode on 2177 kHz or dual watch or scan will
monitor the channel on
SAILOR 6300 MF/HF
DSC logs can also be downloaded accessing the IP address of the
radio with a standard web browser.
To Next Page
Loading...
