Chapter 3: Service & maintenance
66 Diagnostics
Diagnostics
Diagnostics
In the Diagnostics menu in SETUP the following submenus are available:
• Log with system status messages
• Self Test
• ATU status
Log with system status messages
In the Log menu you can view the system status, with time, date and a
description (besides a technician code). The system status is not an error
log. It is a log with issues logged by the radio during normal use.
Example: Bad SWR, which may occur in poor installations, hard weather
making the transmitter antenna sway, etc.
To view system messages, do as follows:
1. Press the soft key SETUP. If it is not in the display, press the soft key
MORE until SETUP appears.
2. Press the arrow soft key or to advance to and select Diagnostics
and then Log.
3. Turn the selector knob to go to a setting, then press the selector knob to
view the system setting.
4. Press EXIT to return to normal radio operation.
If the message ATU: No Comm. appears in the display during
normal use, this might be a temporary condition depending on the
current installation. If the problem persists, a pop-up message with
an error message appears in the display.
To Next Page
Loading...
