Chapter 2: Operation
Setup 43
2222
Radio setup
Channel setup
Item Description
Scan
Hang
Time
Scan hang time, in seconds on an active receiving working channel.
The time is measured from the signal is detected. The radio
remains on the channel for the set time interval, if a signal was
detected.
OFF: Resumes scanning when signal disappears (default)
4, 6, 8, 10: Hang time in seconds.
Scan
Resume
Scan resume time, in seconds. When the programmed time of
inactivity has elapsed, and when watch/scan has been aborted
using a push on PTT, or after power-up, scan or watch is resumed.
OFF: Automatic resume is deactivated (default)
3, 6, 10, 15, 20, 25, 30: Resume time in seconds.
Scan
Mode
Scan mode when pushing the soft key SCAN:
— VOICE (SSB voice) or
— MULTI (DSC plus SSB voice, alternating)
External
PTT
ENABLED (For use of an external PTT device, connected to the TU
AUX plug) or DISABLED
Item Description
Watch
Receiver
Push the selector knob to display the watch frequencies and to
show which of these are enabled. Contact your local distributor for
modifications.
Private
Channels
Read only. Contact your local distributor for adding private
channels.
DSC
Watch
The frequency watched for dual watch or multi scan. To receive
routine DSC calls set this frequency to 2177.
To Next Page
Loading...
