Chapter 2: Operation
48 Setup
NMEA in (baud)
(only displayed
when NMEA TU
or NMEA CU is
selected)
The actual baud rate of the NMEA input port selected
4800
LWE Talkers
(only displayed
when Automatic
or one of the
LWE sources is
selected)
When Automatic mode is selected updating is shown to
indicate the equipment is currently scanning for devices on
the LAN network.
This process may take up to 40 seconds.
- LWE1
- LWE2
- LWE3
Or
- LWE1
- LWE2
- LWE3
CCXXXX In automatic mode this position holds the highest
priority GNSS position source after a scan.
If a third party position source shall be used in the LWE
priority, the LWE talker is simply programmed on the desired
priority position (LWE1, LWE2 or LWE3). A manually
programmed source is indicated by a key symbol (). The
manually programmed LWE sources can be removed by
deleting the entry completely.
LWE Identity CCXXXX As default the device identity is automatically
created. Manual override requires password entry.
Factory Defaults Resets the radio to factory defaults after power cycle.
Password If you need to change the identity of the radio (MMSI
number or disabling the ATU), contact your local dealer.
Radio info
• SW Version: Software version of the Transceiver Unit
• S/N: Serial number of the of the Transceiver Unit
• TU IP: IP address of the Transceiver Unit
Item Description
To Next Page
