Chapter 2: Operation
Setup 49
2222
Controller setup
Item Description
Handset 1 vol: Adjust earpiece volume for handset 1: can be adjusted
from 0 to 100, in steps of 5.
Note: Default setting is 80. The handset connected to
the front connector has top priority and is configured to
80. The volume can be adjusted from 0 to 100, in steps of
5.
Handset 2 vol: Adjust earpiece volume for handset 2: can be adjusted
from 0 to 100, in steps of 5.
Note: Default setting is 0. If a handset is connected to the
rear connector this value must be configured to a value (0
to 100, in steps of 5).
Wheel lock: You can set a time interval after which the RF gain,
volume and selector knobs are locked and protected
against unintentional use. Then a lock symbol is shown in
the display. Push any key to unlock the knobs.
OFF, 10s, 20s, 30s, 40s, 50s, 60s
High priority
• Yes — This MF/HF radio (Control Unit) can override
the other Control Unit connected to the same
Transceiver Unit.
• No — This MF/HF radio (Control Unit) cannot override
the other Control Unit.
Controller Info
• SW Version: Software version of the Control Unit
• S/N: Serial number of the of the Control Unit
• IP: IP address of the of the Control Unit
To Next Page
Loading...
