Quick Start Operation Operation Manual Sea Tel TV & TVHD
1-3
BLOCK -
ON (Solid Red) indicates that the antenna is within a defined blockage zone (therefore you should not have
satellite signal until the antenna is no longer within the blockage zone).
OFF indicates that the antenna is not within a defined blockage zone). If no blockage zones have been
entered, the antenna could be blocked causing loss of signal.
LINK - (Green LED)
ON (Solid Green) indicates that the LMXP has good communications with the antenna (therefore good
antenna control). This is normal state for system operation.
ON (Solid Red) indicates LOSS of communications with the antenna (therefore, loss of antenna control).
Check the coax connections on the LMXP and in the base of the radome.
STATUS - (Green LED)
ON (Solid Red) indicates that the signal is below threshold (satellite signal is low or lost).
OFF indicates that status is normal.
POWER - (Green LED)
OFF indicates that LMXP Power switch is OFF (No power to the LMXP or the antenna).
ON (Flashing Green) indicates that the LMXP is booting up.
ON (Solid Green) indicates that the LMXP boot sequence is complete and the system power is ON (normal).
To Next Page
