Name Description
1 Power/Standby Turn the unit on or o (standby). The Main Power switch on the
rear panel must be set to the ON position.
2 Numeric Keypad <0-9, 10>: Use the numeric keypad to input numbers where
appropriate.
<+10>: Add 10 to input numbers higher than 10. For example,
press <+10> twice and then press <5> to input the number “25”.
3 GOTO Enter Direct Access mode to go to a specic part of a movie.
4 SETUP Enter the main setup menu of the unit.
5 SOURCE Change the source input mode of the unit (e.g., DVD-VIDEO, LINE,
TUNER).
6 USB Change the source input mode between DVD, USB, and CARD.
Press <SOURCE> to place the unit in DVD mode rst to access the
USB and memory card source modes.
7 A-MODE Toggle the audio mode between STEREO OUPUT and 5.1 CHANNEL
OUTPUT.
8 PLAY/PAUSE Play or pause the disc.
9 V-MODE Change the video output mode of the unit to match the video con-
nection used. Select CVBS for 480i composite video, YUV for 480i
component video, or P-YUV for 480p component video.
10 PROG Enter Program mode to create a custom playlist.
11 STOP Press once to stop disc playback. The player will save and resume
playback from the stop location.
Press twice to stop disc playback completely. The player will
resume playback from the beginning of the disc.
12 OSD Toggle on-screen information display.
13 VOL+ Increase the volume level.
VOL– Decrease the volume level.
DVD938 at a Glance
To Next Page
Loading...
