Digital Audio Setup
Digital Output
Set this option to SPDIF/RAW or SPDIF/PCM to activate the coaxial
digital audio output connection.
SPDIF/OFF: There will be no digital audio signal output. (Coaxial
o)
SPDIF/RAW: The digital audio signal output will be in its raw for-
mat. This mode is usually used for DTS & Dolby Digital . signals.
SPDIF/PCM: The digital audio signal output will be in PCM format.
This mode is usually used for audio CD signals.
LPCM Out
When the DIGITAL OUTPUT option is set to SPDIF/PCM, this item is
available.
Select a sample rating for the analog audio output. There are two op-
tions, KHz and KHz.
Use the standard 48 KHz option unless your amplier/receiver
can support a sample rate of 96 KHz over a coaxial digital con-
nection.
Dolby Digital Setup
Dual Mono
STEREO: The player outputs the left-channel audio and right-chan-
nel audio via the FL and FR speaker respectively.
L-MONO: The player outputs the left-channel audio only via both
the FL and FR speaker.
System Setup
To Next Page
Loading...
