Cochlear Nucleus CP802 - Attaching the Processing Unit and Battery Pack

Attach the processing unit and battery pack
1. Hold the processing unit
and the upper end of the
Cochlear
™
Nucleus
®
CP802
Battery Pack Cable at an
angle and twist together as
shown.
2. Line up the Cochlear logo
and dot marks on the lower
end of the battery pack cable
and on the battery pack.
3. Connect the plug on the
battery pack cable to the
socket on the battery pack.
Tip: You can lock the battery pack cable by pushing the lock below the accessory
socket to the far left position. To unlock, push the lock to the far right position.
4. Insert the battery pack into
the Cochlear
™
Nucleus
®
CP802 Battery Pack Clip, at
an angle.
5. Line up the hinge on the
battery pack with the slot
on the clip and twist gently
until the clip clicks into
place.
6. Clip the battery pack to your
clothes.
To remove the battery pack cable:
© Cochlear Limited 2016 CP802 Sound Processor User Guide - 11