15
3. Connection
3-1. Necessary connection
Connect a loudspeaker to the speaker connectors, and then connect AC adapter to the X10 like
the picture below and switch ON the X10.
【 TIP ① 】 When you connect to a loudspeaker, make sure the X10 is NOT powered.
3-2. The specification of X10 Amplifier
z Rated Output of speaker out : 30W + 30W @ 1KHz, 8 ohm, 1% THD
X10 is designed for 8 ohm loudspeaker.
z Head phone out : 100mW + 10mW @ 1KHz, 16 ohm, 0.1% THD
z Line Out : 2Vrms @ 1KHz, 0.1% THD
z Input sensitivity of Line(AUX) In : Max 1Vrms
3-3. Passive loudspeaker & Active loudspeaker
◆ What’s a passive loudspeaker? : Passive loudspeaker does not have a power amplifier
inside. This must be connected via the speaker connector of X10.
◆ What’s an active loudspeaker? : Active loudspeaker has a power amplifier inside. This
must be connected via the LINE-out of X10.
To Next Page
Loading...
