16
3-4. Extra Connection
Various devices such as headphone, professional amplifier, decoder, turntable, USB devices,
computers, routers can be connected to the X10 due to the different connectors at rear panel.
4. Turn On and Start
4-1. Wizard Setup (Setup Assistant)
When you do 1
st
booting up after X10 purchase and do 1
st
booting up after factory reset, you will
meet Setup Assistant (Wizard Setup) like below. Switch on first with the dip switch at the rear of
X10 and power it on with the remote controller or the power button on the top of X10.
Select OK and confirm it with OK key to start Wizard Setup. If you want to set up after
completing booting up, you may select CANCEL at the 1
st
step.
【 TIP ① 】 You will be asked about HDD format in case only that the installed HDD is NOT
formatted.
4-2. Turn ON for normal use
Switch on first with the dip switch at the rear of X10 and power it on with the remote controller
or the power button on the top of X10 – should take about 66 seconds to boot up in case that
network is connected.
【 TIP ① 】 After you press power on button, it will take around 20 seconds until booting-up logo
shows up on the screen.
To Next Page
Loading...
