Error message Resolution
Link lost, unable to send message The data link to the remote station was lost.
Check your antenna, re-tune (if using the
internal tuner) and re-position if possible and
try again.
Maximum number of users connected No more than 4 control points can be
connected to the radio simultaneously.
Message required Blank text messages cannot be sent.
Messages require at least 1 character.
Name is not unique This name has been used for another entry
New PINs do not match The pin and re-enter pin field do not match.
No channel for call on HF network ... The selected HF network does not have a
channel that it can make a call on. Either there
are no channels available for this network or
the channels do not have a valid mode set
No USB device connected The connection to the USB device is lost.
Check that the USB device is connected
correctly and try again.
No voice or data key is set No key has been set in the secure key index.
press the secure macro key and navigate to
Secure Key Index. Select a key and press
Activate.
No voice or data keys programmed No encryption keys exist for the current secure
mode
Overwrite with current GPS position? This action will overwrite the existing GPS
coordinates with the coordinates detected by
the GPS receiver
Phone number required A telephone number entry is needed for this
call type
PTT rejected Another PTT source is active Another handset has pressed push-to-talk, the
input on the current handset has been
disabled
PTT rejected Rx-only frequency The radio is set to receive only. Push-to-talk is
not available
Rate selection not permitted The selected digital voice rate is not permitted
on this radio, select a different rate
Troubleshooting
Sentry-H 6110-MP Operator Guide Page 59
To Next Page
Loading...
Need help?
General