Error message Resolution
Record voice message timeout The Voice Message screen has timed out. You
will need to re-record your message
RM50 module not detected. Proceed anyway? The radio does not detect an RM50 module.
This may affect the outcome of the requested
action.
RM50 power on failed The RM50 module has failed to start up. Digital
Voice, 2G/3G ALE data, and security is not
available on this radio.
RM50 power on timeout The RM50 module has failed boot within the
timeout period. 2G/3G ALE data and security
is not available on this radio.
Rx frequency is out of range The HF band is between 1,600 kHz and 30,000
kHz, values outside of that range are not
available on this radio
Screen closed due to remote update The radio is being updated by another device,
and the current screen has been closed to
allow for this update.
Secure not supported while hopping is on AES-256 Encryption is not available when
hopping is on. Only CES-128 encryption is
compatible with hopping
Settings conflict with sales options The radio has been configured with settings
that are incompatible with the features
available on your radio. These settings will
have no effect.
Start-up Error Please restart unit If error
persists, please contact Codan
A start-up error has occurred. Hold the Power
key for 2 seconds, then release to power down
the radio, press the power key again to restart
the radio. If the problem persists, contact your
HF Network Administrator or Codan
representative.
System busy The selected action is not available as the
radio is performing another action. Wait for the
system to finish this action before trying again.
System initialising... Please try again The selected action is not available while the
radio is starting. Wait for the system to startup
before trying again.
Time not valid The time entered is not valid, the format is
Hours minutes seconds
Troubleshooting
Page 60 Sentry-H 6110-MP Operator Guide
To Next Page
Loading...
Need help?
General