Codan Sentry-H 6110-MP User Manual

Testing your radio before
deployment
Once assembled, the radio should be tested to ensure that everything is working correctly. The
following tests should be run before the radio is deployed. Testing involves:
• running a diagnostic self-test; and
• measuring the standing wave ratio (SWR) of your channels; and
• carrying out station-to-station on-air testing.
Running a Self Test
The Self Test allows the radio to run through a series of checks to ensure that the radio is
operating. The CP LCD and CP Keys tests require your input in order to complete.
 Note: The self test will only test the control point that it was run from. If you have a 2320
handset connected to your radio, you should run the self test on both the front panel as
well as the 2320 handset.
 Note: You can press PTT at any time to abort the self-test.
1. Switch on the Radio (page 15).
2. Press the key.
3. Select Self Test Screen from the Function Select screen.
4. Press (Start).
Testing your radio before deployment
Page 10 Sentry-H 6110-MP Operator Guide

Codan Sentry-H 6110-MP Specifications

General

Brand	Codan
Model	Sentry-H 6110-MP
Category	Radio
Language	English