D018433_01_CR4405_User_Manual
12.0 - Reading Ranges
CR4405 Performance
Test Barcode Min Inches (mm) Max Inches (mm)
3 mil Code 39 3.1” (80 mm) 4.0” (102 mm)
7.5 mil Code 39 1.3” (33 mm) 7.2” (182 mm)
10.5 mil GS1 DataBar 0.8” (20 mm) 8.7” (220 mm)
13 mil UPC 1.1”(28 mm) 11.0” (280 mm)
5 mil Data Matrix 1.7” (43 mm) 4.5” (115 mm)
6.3 mil Data Matrix 1.3” (33 mm) 5.9” (150 mm)
10 mil Data Matrix 0.8” (20 mm) 7.1” (180 mm)
20.8 mil Data Matrix 1.1” (28 mm) 13.5” (343 mm)
Note: Working ranges are a combinaon of both the wide and high density elds. All samples were high quality barcodes
and were read along a physical center line at a 10° angle. Default AGC sengs were used. Accuracy= +/- 10%.
6
The following symbologies are enabled by default. To turn symbologies on or o, scan the symbology barcodes located in the
CR4405 Conguraon Guide located on our website at hp://www.codecorp.com/les.php.
10.0 - Symbologies Defaulted On
11.0 - Symbologies Defaulted O
Code barcode readers can read a number of symbologies that are not enabled by default. For a complete list (and the conguraon
barcodes to enable those symbologies), please reference the CR4405 Conguraon Guide located on our website at
www.codecorp.com/les.php.
13.0 - CR4405 Sled Reader Conguraon
The CR4405 can be congured for specic tasks, data manipulaon, or operaonal modes by scanning conguraon barcodes
found in the CR44x5 Conguraon Guide at www.codecorp.com/les.php.
Aztec
Codabar
Code 39
Code 93
Code 128
Data Matrix
MSI Plessey
PDF417
QR Code
UPC/EAN/JAN
Data Matrix Rectangle
All GS1 DataBar
Interleaved 2 of 5