(24) Wipe clean all accessible inner and outer surfaces of the machine.
Wipe dry.
(25) Refit the whipper bases, paddles, mixing bowls, tubes and dispense
nozzles and brewer parts. The assembly procedure for the brewer is
the reverse of the disassembly procedure. Ensure that both brewer-
locking levers are in the locked, (horizontal position) before proceeding
to the next section.
(26) Replace the grouts collection bin and refit the front cover, ingredient
canister
(27) Turn on the power. Note the brewer will cycle to reach its home
position.
(28) Carry Out a FLUSH operation, see below. Check that there are no
leaks and that the brewer indexes properly. A container with a
capacity of at least ½ liter should be placed beneath the dispense
point to catch the liquid dispensed during the flush operation.
(29) Filter Belt Replacement
To Next Page
Loading...
Need help?
General