(1) Using fore finger and thumb compress the tensioning rollers as shown in A.
(2) With the rollers compressed push and turn the red lever to the locked
position as shown in B.
(3) With the rollers locked in the compressed position the belt can now be
removed.
(4) The belt may be cleaned using de-staining solution but will progressively
become blocked with scale and therefore require more frequent cleaning. A
new belt will perform approximately 1000 vends before cleaning is required.
It is recommended that a belt is replaced in any case after approximately
3000 vends.
(5) Replace the filter belt making sure to thread the bottom edge beneath the
scraper plate. Once the belt has been threaded over all three rollers it can
be eased into place by sliding it sideways whilst turning the drive shaft.
(6) Once the belt is in place press the red lever to release the tensioning roller
and tighten the belt.
FLUSHIN
G THE “ESPRESSO” BREWER – TO BE DONE EVERY 3 MONTHS
• Ensure both the water waste and grout buckets are in place as they are
To Next Page
Loading...
Need help?
General