R1000H
Alarmlist
Version: 2
Page: 5
Date: 07.11.2022
TROUBLE SHOOTING TABLE
Troubleshooting Alarm test Description
1 Both_1_AND_2 Program error. More than one group started at a time.
Contact IceTech technical support.
2 Both_BG1_AND_BG2 Both sensors are active and shouldn't be.
Investigate if both sensors are actually active and replace damaged
component if needed.
3 Emergency_Stop Emergency stop is active.
Release emergency stop or replace component if damaged.
4 Error Program error
Contact IceTech technical support.
5 Fault Program fault
Contact IceTech technical support.
6 Feedback Feedback not available
Contact IceTech technical support.
7 Hardware Hardware error
Contact IceTech technical support.
8 Hardware_Error Hardware error
Contact IceTech technical support.
9 Input_Not_High Input is not high as expected
Check if component / sensor is working as expected.
10 Input_Not_Low Input is not low as expected
Check if component / sensor is working as expected.
11 Inverter Inverter error
Contact IceTech technical support.
12 Max_ActionTime Max. actiontime
Contact IceTech technical support.
13 MCB Error on main circuit breaker.
Check if the main circuit is engaged and if the is a short circuit /
components failure causing the MCB to trip out.
14 Not_Emergency_OK Program error
Contact IceTech technical support.
15 Not_Enable Program error
Contact IceTech technical support.
16 Not_Enable_1 Program error
Contact IceTech technical support.
17 Not_Enable_2 Program error
Contact IceTech technical support.
18 Not_QuickStop_OK Program error
Contact IceTech technical support.
19 Overrange Short circuit
To Next Page
Loading...
