4-16 Cole Palmer
Section 4 Operation
Ensure the stop symbol is highlighted, if not use the arrow keys to navi-
gate to the symbol.
Press . The unit will stop and the stop symbol will turn into a start
symbol ( ).
Stopping
the Unit
Press . The controller's screen will go blank .
Place the circuit protector on the front of the unit to the O
position.
Using any other means to shut the unit down can reduce the life
of the compressor.
Always turn the unit off and disconnect it from its supply voltage
before moving the unit.
The circuit protector located on the front of the unit is not intend-
ed to act as a disconnecting means.
NOTE When quickly restarting, the compressor may take up to 10 min-
utes before it starts to operate.
Power Down
Shut Down
Restarting
20.0°C
24.2°C
SP1 Menu
Stop Symbol
I
O
To Next Page
Loading...
Need help?
General
