Need help?Do you have a question about the Colorlight X4 and is the answer not in the manual?
Details the controls and display on the front of the Colorlight X4 controller.
Illustrates and describes the connectors and ports on the rear of the device.
Lists and describes the various physical video input connectors available on the device.
Details the physical output connectors, primarily Ethernet ports, for connecting to LED screens.
Identifies the USB ports used for connecting to a PC for configuration and cascading.
Guides on using LEDVISION software to detect connected sender and receiving hardware.
Instructions for configuring LED screen parameters within the software.
Details on setting up the sender device, including signal source and scaling.
Procedure for setting sender resolution and frame rate using EDID.
Procedure to detect and acquire information about connected receiving cards.
Steps for configuring screen parameters for normal display.
Steps for setting up connection parameters between receiving cards and the sender.
Explains how to navigate menus and adjust settings using the knob and buttons.
Describes the information shown on the device's LCD screen when idle.
Lists the 8 main operation categories accessible from the menu.
Covers adjustments for brightness, color temperature, black screen, and test modes.
Allows setting conventional resolution or custom width, height, and frame rate.
Enables or disables VGA/CVBS input preference for signal selection.
Enables clipping and setting X, Y, width, and height for input signals.
Allows adjusting X, Y, width, and height for the output signal.
Provides options for shifting the whole image or by port.
Enables switching the device's user interface language.
Includes options for date/time, factory reset, and firmware version check.
Details the controls and display on the front of the Colorlight X4 controller.
Illustrates and describes the connectors and ports on the rear of the device.
Lists and describes the various physical video input connectors available on the device.
Details the physical output connectors, primarily Ethernet ports, for connecting to LED screens.
Identifies the USB ports used for connecting to a PC for configuration and cascading.
Guides on using LEDVISION software to detect connected sender and receiving hardware.
Instructions for configuring LED screen parameters within the software.
Details on setting up the sender device, including signal source and scaling.
Procedure for setting sender resolution and frame rate using EDID.
Procedure to detect and acquire information about connected receiving cards.
Steps for configuring screen parameters for normal display.
Steps for setting up connection parameters between receiving cards and the sender.
Explains how to navigate menus and adjust settings using the knob and buttons.
Describes the information shown on the device's LCD screen when idle.
Lists the 8 main operation categories accessible from the menu.
Covers adjustments for brightness, color temperature, black screen, and test modes.
Allows setting conventional resolution or custom width, height, and frame rate.
Enables or disables VGA/CVBS input preference for signal selection.
Enables clipping and setting X, Y, width, and height for input signals.
Allows adjusting X, Y, width, and height for the output signal.
Provides options for shifting the whole image or by port.
Enables switching the device's user interface language.
Includes options for date/time, factory reset, and firmware version check.
General| Brand | Colorlight |
|---|---|
| Model | X4 |
| Category | Controller |
| Language | English |
To Next Page
